Page 1 of 1
fujitsu/icl cash register
Posted: Fri Jan 02, 2004 4:14 pm
by Guest
dose anyone know how to get one of these to work with dhpos?
thanks,
-Nick
opse
Posted: Fri Jan 02, 2004 4:15 pm
by Guest
Should Work
Posted: Fri Jan 02, 2004 4:28 pm
by ChrisKraus
Well, From The looks of it, It should work. You might have to Unzip DHPOS and put it on a Floppy (or two) and then load it on to the Cash Register.
- Chris
Cash register
Posted: Fri Jan 02, 2004 5:04 pm
by Dale Harris
Nick,
I am not sure about that printer. How does it work? Also do you have the printer codes that will make the printer pop open the cash drawer, assuming that the cash drawer is connected to a port on the printer.
I fix the printers for these
Posted: Fri Jan 02, 2004 5:42 pm
by Alan
Hi folks,
We call that unit an "Atrium" at work (we used to be part of Fujitsu/ICL) Its the predecessor to the TeamPOS, that somebody else found on eBay recently. 8)
I'm really unsure if the printer will work with DH-POS as it is a serial "type"
Alan
question for allan
Posted: Sat Jan 03, 2004 12:06 am
by Guest
do you rember the serial specs for the printer or know how i can program the keyboard?
thanks again,
-nick
Well..
Posted: Sat Jan 03, 2004 4:34 am
by Alan
There are'nt any serial specs for the printer, its just a "serial" type! Its proprietary ICL nonsense, that requires their custom made drivers.
Alas we no longer fix the base units, so I don't have any access to drivers etc.
Alan
