BIG Pole Display
Posted: Sat Jun 28, 2008 8:26 pm
I am trying to use a second monitor as the pole display, when I select to 20 coloum output it always goes back and maxamises over the primary monitor even though I move it to the second monitor.
Also then I run the POS in full screen mode in black out the second monitor therefore not allowing me to use a windowed display on the second screen unless I run the POS in a window rather than full screen.
Any suggestions?
Jason
P.S. Apart from these couple of issues this would have to be the greatest little POS programme I have tried and would certainly reccomend it to anyone.
Also then I run the POS in full screen mode in black out the second monitor therefore not allowing me to use a windowed display on the second screen unless I run the POS in a window rather than full screen.
Any suggestions?
Jason
P.S. Apart from these couple of issues this would have to be the greatest little POS programme I have tried and would certainly reccomend it to anyone.