How to: returning stuff to vendor
Posted: Thu Mar 03, 2011 5:33 am
Hi there!
I'm using this software for quite a while now (actually I'm using it for 4 months) and I find it amazing, But (as there is allways one) I do have some questions.
First off: I have returned some of my stock to the vendor (shelf life gone bad) and now, I do not know how to enter the "negative amount" into the recieving programme (it won't let me )
Second: I wrote about this one to Dale but I guess he is too bussy to deal with such minor thing so here goes: I'm using OKIPOS 90 series printer attached to my LPT port. Right to the other day everything was fine, then all-of-the-sudden the cutter went gugu and started cutting twice (like it cuts at the end of the receipt and then paper feeds for about 1/2 inch and cuts again. I've tried everything in my knowledge to no avail.
So, does any of you, guys, have any idea regarding my Q's?
I'm using this software for quite a while now (actually I'm using it for 4 months) and I find it amazing, But (as there is allways one) I do have some questions.
First off: I have returned some of my stock to the vendor (shelf life gone bad) and now, I do not know how to enter the "negative amount" into the recieving programme (it won't let me )
Second: I wrote about this one to Dale but I guess he is too bussy to deal with such minor thing so here goes: I'm using OKIPOS 90 series printer attached to my LPT port. Right to the other day everything was fine, then all-of-the-sudden the cutter went gugu and started cutting twice (like it cuts at the end of the receipt and then paper feeds for about 1/2 inch and cuts again. I've tried everything in my knowledge to no avail.
So, does any of you, guys, have any idea regarding my Q's?