Page 1 of 1
Search By Vendor Code
Posted: Sun Apr 18, 2004 5:51 pm
by Fez
Hi all
Is it possible to set the POS prog to search using vendor code by default instead of pressing * (SHIFT+8) to switch from bar code to vendor code.
Fez
South Africa
Posted: Mon Apr 19, 2004 2:09 am
by Andrew
No, not at this point. Because you would normally have more than one item under a single vendor code.
Thus, a search displays a list of the products from that vendor.
Posted: Mon Apr 19, 2004 5:24 am
by suamme1
Also, I've found that POS works better with an extended keyboard with a dedicated number pad on the right. With this, you can just hit the (*) key with no shifting and entering numbers and the (+) key is super easy.
Most notebook computers will support a PS2 keyboard for this that is easier to type on, can be connected and disconnected at any time on most notebooks, and can be bought for around $10 US.
Posted: Mon Apr 19, 2004 8:11 am
by Jonathan
Also, for notebooks, look into a dedicated number pad... it plugs into the keyboard port on the back and gives you the number pad missing from most laptop keyboards.
Jonathan Simpson