DHES

I've been testing a Partner Tech CD7220 pole display using the command set for the Logic Controls emulation (UTC standard mode). My other POS system using the Logic Controls setup works great with this pole display. I get a blank display when running DHPOS - no response from the program. I can send commands to COM1: from the command line (DOS prompt) and the display responds as it should. Running 9600,n,8,1.

I've run POSCONFG and set the com parameters to COM1:, 9600, 8,1,N. Run POLE.EXE before starting POS. POLE.CFG shows the correct com port parameters. Any ideas?

-- recycle_ben