Pole Display

Make comments, ask questions, or just complain about the software on this site. Or comment on any educational software.
Please note that by clicking on links that may appear in these posts that you may be leaving the Dale Harris Educational Software website and that the content of those sites is the sole resposibility of the authors of those sites.

Moderators:daleadmin, Dale Harris, Alan, Andrew

Guest
Pole Display

Post by Guest » Thu Jun 16, 2005 5:33 pm

I've been testing a Partner Tech CD7220 pole display using the command set for the Logic Controls emulation (UTC standard mode). My other POS system using the Logic Controls setup works great with this pole display. I get a blank display when running DHPOS - no response from the program. I can send commands to COM1: from the command line (DOS prompt) and the display responds as it should. Running 9600,n,8,1.

I've run POSCONFG and set the com parameters to COM1:, 9600, 8,1,N. Run POLE.EXE before starting POS. POLE.CFG shows the correct com port parameters. Any ideas?

-- recycle_ben

Post Reply

Who is online

Users browsing this forum: No registered users and 26 guests