Hi I have a Symbol LS2000MX barcode reader, with an RJ45 to a 9 pin serial connector. Nothing happens when it is plugged into a PC serial port, but i know you can get a wedge cable for this type of scanner. My question is, is there a piece of software to make the scanner work or will I need to replace the cable / wire the existing cable into a keyboard?
I am new to POS hardware so any advice would be greatly appreciated, thanks.
Barcode Reader Question
Moderators:daleadmin, Dale Harris, Alan, Andrew
try this
hey most serial scanners require a power supply .i have the same scanner and i had to get a power supply for it to work
it does work
to turn on the option in win 9x and 2000 and nt
open control pannels
open accesibility
under one of the tabs there is a option checkbox to turn on serial keys
check this box
click apply
click ok
a restart may be required
YOU WILL STILL NEED A POWER SUPPLY
it does work
to turn on the option in win 9x and 2000 and nt
open control pannels
open accesibility
under one of the tabs there is a option checkbox to turn on serial keys
check this box
click apply
click ok
a restart may be required
YOU WILL STILL NEED A POWER SUPPLY
- ibmsystems
- Forum Regular
- Posts:425
- Joined:Tue Oct 25, 2005 10:54 pm
- Location:London - UK
Problem With Power For LS2000
Hi,
I Think You Guy's May Have Already Fixed This But Usually Symbol Scanners With MX And 0 And The End Of The Model Require A LL-500 Omni-Link That Supplies Power And Decode's The Barcode Scanners Such As The Symbol LS2208 Have A Decoder Built In The Handle
DK
I Think You Guy's May Have Already Fixed This But Usually Symbol Scanners With MX And 0 And The End Of The Model Require A LL-500 Omni-Link That Supplies Power And Decode's The Barcode Scanners Such As The Symbol LS2208 Have A Decoder Built In The Handle
DK
Who is online
Users browsing this forum: No registered users and 212 guests